Thingiverse
223 Bullet Feeder Die by DPGunworks
by Thingiverse
Last crawled date: 5 years, 1 month ago
7/8 Die. Two detent positions, Upper detent for 60 and higher grain projectiles. Lower detent used for 55gr and lower projectiles. Uses only one detent ball
Print at 1.6 layer height. Reduce print speed to 40mms using PLA on OEM 16 bit mother boards. Works with PETG at same print speeds. Print with Supports at 70 degree or more overhang only
bullet feeder die use one (1) 5/32 or 4mm detent ball bearings and two (2) 13/64 x 13/16 extension springs or rubber band and 1/2 x (bullet diameter) plexiglass tubing. Links these can be found below
Plexiglass tubing:https://www.eplastics.com/shapes/plexiglass/tube/clear-extruded
Print at 1.6 layer height. Reduce print speed to 40mms using PLA on OEM 16 bit mother boards. Works with PETG at same print speeds. Print with Supports at 70 degree or more overhang only
bullet feeder die use one (1) 5/32 or 4mm detent ball bearings and two (2) 13/64 x 13/16 extension springs or rubber band and 1/2 x (bullet diameter) plexiglass tubing. Links these can be found below
Plexiglass tubing:https://www.eplastics.com/shapes/plexiglass/tube/clear-extruded