Thingiverse
2020 DrawBot w/ Installation & Use Instructions by henryarnold
by Thingiverse
Last crawled date: 4 years, 7 months ago
I posted this as remix because "makes" don't allow you to add files. I created an installation and use manual which is helpful for using this DrawBot. It explains how to install the Inkscape software and extension and how to use the Universal G-Code Sender. See the attached file. I also created mounting points for the 24" wire tie that I used to support the cable that runs over to the carriage.
This is the original Thing by wsolstice69https://www.thingiverse.com/thing:2374238
My cable support mount pointhttps://www.thingiverse.com/thing:2829025
This design makes a great drawing robot. It is inexpensive to build, easy to assemble, and is very accurate. Although I haven't done so, it should also be easy to add a laser cutter to this machine.
This is the original Thing by wsolstice69https://www.thingiverse.com/thing:2374238
My cable support mount pointhttps://www.thingiverse.com/thing:2829025
This design makes a great drawing robot. It is inexpensive to build, easy to assemble, and is very accurate. Although I haven't done so, it should also be easy to add a laser cutter to this machine.