1mm Punch by Charvey0003

.... print hole punch sheet at 100% lay over top of your teflon film and punch out the holes, hardware: #6-32 nuts and bolts or m3 .

...e is 1/2in. in diameter. for the dollar coin punch card, the punch hole is 5/8in in diameter. these are made for a die punch set.

...punch tray by seanmanagh thingiverse punch trays

...punches holder by iarmandgaming thingiverse this is a punches holder

...ck. because the steel punches are longer than the brass, the holes are all the same depth and the steel punches sit in the back.

...smaller size will also fit the punches for the harbour freight version. i always hated having to dig out the box to get punches!

...coffee punch thingiverse punch vor coffee maker

...4g punching by army310 thingiverse something you got to punch

...hex punches by batter thingiverse test designs for hex punches.

...dino biscuit punch by poneymort thingiverse a stegosaurus biscuit punch

...smile ring by charvey0003 thingiverse smile ring

...test 2 by charvey0003 thingiverse part for test 2

...vase with water spout by charvey0003 thingiverse a vase with a spout to water your flowers ;)

...modular emergency charger case by charvey0003 thingiverse case for a modular battery powered emergency usb charger.

...coffee punch thingiverse punch vor coffee maker

...smaller size will also fit the punches for the harbour freight version. i always hated having to dig out the box to get punches!

...bearing punch thingiverse basic bearing punch i designed for removing bearings from crank cases etc

...punch tray by seanmanagh thingiverse punch trays

...punches holder by iarmandgaming thingiverse this is a punches holder

...ck. because the steel punches are longer than the brass, the holes are all the same depth and the steel punches sit in the back.

...sache punch thingiverse a handy mayonnaise, ketchup or mustard sachet punch. it is 3.5 cm i recommend using support.

... with other models, but i havent tested any other hole puncher. 0.1 x 0.2 cm no supports needed let me know if you need any help.

...4g punching by army310 thingiverse something you got to punch

...pertinax 1mm bedholder by garyk47 thingiverse holder for 1mm pertinax bed.

...guitar pick 1mm by kcrede thingiverse guitar pick 1mm cool pick

...quicklink for 1mm wire by milcent thingiverse this is a quick link for 1mm wire used on rc plane

...stride control - across 1mm by printelx thingiverse stride control - across 1mm

...80mm fan filter 1mm by edd77 thingiverse 80mm fan filter 1mm

...whoop motor spacer 1mm by al3k87 thingiverse 1mm motor spacer for 9mm hole to hole.

...vase 1mm wall-thickness by 3ndosymbiont thingiverse ready to print vase with 1mm wall-thickness.

...mirochi xts 1mm softmount by bozzziidrones thingiverse motor softmount and arm protection in 1mm thickness

...walls stepped 1mm x 10mm by nathanshearer thingiverse 1mm thick wall. each section is 10mm long and rises by 1mm.