1:6 SCALE CAPTURE CAGE/UTILITY TRAILER W/WORKING TOOL BOX AND TAIL GATE by dstarr3311

Last crawled date: 3 years, 1 month ago

UPDATED VERSION ALL ERRORS WERE FIXED.........FINALLY..........
Here is a 1:6 scale custom made Capture Cage/Utility trailer w/ working tool box and tail gate minus tires and axle for you G.I.Joe R.C. Adventures measures 11" L-X-10"W-X-6"D with tires on it this trailer will need the following to complete it, 1- set of Jeep tires 1- metal axle 5mm red led lights for tail lights 1- set of micro hinges 1- set of Shappy Micro JST PH 2.0 2-Pin Connector Plug Male and 20 Pieces 10 cm Red and Black Silicone Cable Wire with Female Connector at amazon.com [ see fifth pic for that ] and/or 9vt battery and connector plug and you will need to make 2 see through red lenses with led holder for the tail lights. hot glue to glue the wiring in place...you will also need part no# CD15828TCG_SIXER1 Trailer Hook to go on your jeep or truck by capo you can get this at KAIOZ RC STUDIOS online............there is a small gap underneath the trailer just deep enough to run the wiring through to the front the gap goes underneath the fender and up to the light bracket ..enlarge the hole if needed...most importantly you will need to do a small modification to your rc vehicle by disassembling it drilling a small hole in rear of body run wires through hole to connect the lights,by finding the light control board in the rc vehicle and soldering the female JST PH 2.0 2-Pin Connector Plug wires to it be sure the wires are long enough or for manual use the tool box can be modified to hold the 9vt battery by just simply drilling a hole in the side of it and soldering the tail lights wiring to the 9vt battery plug wiring install wheels and axle and tail gate and your ready to go........grab a good Jeep the Trailer some scale bungee cords the Capture cage and a rifle or two a tranquilizer gun a few African guides some helpers and your G.I.Joe's ready to go on that African Safari...he he he..... I even included 2 ramps for this and there is a ramp storage rack underneath the trailer in the back beneath the tailgate will be adding a trailer build instruction sheet after I am finished with it, also be sure to thicken everything up before printing this was made using Sketchup and will only print using compatible Maker bot software
enjoy