Thingiverse
15mm x 5mm magnet holder by db2000
by Thingiverse
Last crawled date: 4 years, 5 months ago
15mm x 5mm magnet holder.
The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center - a screw. I went with heating and press fit and its been solid.
i didn't use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn't perfect but it worked fine and its behind the magnet anyway - doing this saves breaking out support material.
The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center - a screw. I went with heating and press fit and its been solid.
i didn't use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn't perfect but it worked fine and its behind the magnet anyway - doing this saves breaking out support material.