1/10 rc touring/rally car body subaru wrc 1999 by wang4576

Last crawled date: 3 years, 1 month ago

This is a body for 1/10 touring/rally car.
I made it purely for practicing Solidworks.
This model is not a modification from another model creator.
I design the model from the blueprint of Tamiya. So don't pay too much attention to the details.
width 190mm wheelbase 260mm
It is a 1 to 1 ratio model. You need to scale the model down to 1;10
No mounting holes. You need to mount the body to your chassis on your own.
I may add the windshield in the future.
have fun with it : )
instruction；
assembly the roof first
screw the mount123 to the main frame
then screw the roof to the main frame
then the door
then the front hood and truck
then the bumper
some parts are glued to the body, like the front light, the taillight, and the truck23
For printing the hood and the top, you should let it stand up or at a certain angle to prevent an unsmooth surface.
high res pichttps://i.loli.net/2021/03/28/aBzjfkANwOctGWh.jpghttps://i.loli.net/2021/03/28/DgYxLp9zTReEkQo.jpghttps://i.loli.net/2021/03/28/RpvMbg5NuqnQs4D.jpghttps://i.loli.net/2021/03/28/THjFS71CJmgdlra.jpg
if you have any question, you can contact me via wjy19971219@gmail.com
QQ; 1055934270
中文版介绍
这个模型是本人用于solidworks曲面练手后的副产物
所以你所看到的这个斯巴鲁并非是从其他模型网站上扒下来修改的
因为是照着田宫的蓝图翻的，所以细节就不要太在意了
没有打孔，如何固定车壳请自行解决
建模的比例为1比1，在切片时缩小10倍即可
搭建指南
先组合车顶
把小的固定件拧到车主体上
装门，装前后盖，装前后杠，黏灯，装尾翼
打印前盖,车顶，都要竖起来或呈一个角度，如果直接铺在平台上打，曲面会很粗糙