13 top tooth ti 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Belt-Driven NEMA 17 Linear Motion System
...file. connect the nema 17 stepper motor to the top piece using 3mm bolts, then attach a geared tooth...
thingiverse
free
Full body Turntable, worm gear & spur cog, and final 35 tooth GT2 drive cog by thowe
...from ebay (£12), 18mm plywood for the base and top table (about £25) and 11mm mdf for the centre...
thingiverse
free
"Turbine" Oreo Cookie Grinder by cbarrett159
...uses what i have dubbed a "turbine" design. the top teeth resemble a turbine and are designed so that...
thingiverse
free
Folgertech FT5 Extruder Mount by n23d
...for a 4 screw attachment for better rigidity. the top and bottom plate through holes were eliminated and replaced...
thingiverse
free
MS-Delta Frame by Spaceman9105
...tooth driver pulley some small cable ties to mount endstop 250mm round glass bed electronics: ramps and arduino combo...
thingiverse
free
Z9M3 Rear belt Alignment and Tensioner CoreXY by gallaghersart
...the bolt that applies the pulling force lays on top of the washers. without washer i would think the...
thingiverse
free
Anet A8 E3D Direct X-Carriage w/ Probe (46mm) by truglodite
...tube in to the inverted stock throat, put the motor/topthroat/tube down the hole into the e3d, and tighten the...
thingiverse
free
Fastmike Heng Long Worm Gear Drive by fastmike75
...the 26t-27t gears will gear the tank up, faster top speed, but less turning power. the 29t, 30t gears...
thingiverse
free
RyBot (my D-Bot) by rkrammes
...x/y end stops. i also designed some physical “end stop” to control the collision with the carriage. i found...
thingiverse
free
Mechanical Clock
...bottom_spacers - 3 one_way_rollers - 3 spacer - 5 rear_toppost - 2 rear_minute_idler_gear - 2 hour_idler_gear - 3 3mm...
thingiverse
free
Emerald Flail Snail Monster for Tabletop Games by jawsnoir
...long ribbon of tongue studded with thousands of tiny toothlike structures that act like a rasp, scraping organic matter...
thingiverse
free
DemonDeltaMicro - Simplest reprap delta frame to date. by DjDemonD
...so here: effector, carriages, pen holderhttps://www.tinkercad.com/things/aqadijdevtg-ddm-effector-carriages/editv2 main printer base, topttps://www.tinkercad.com/things/azqtagydzld-demondeltamicro/editv2 base with improved holes for...
grabcad
free
Trapper fishing rod holder
...side to side there is a circular platform on top of the bracket with a disk, with the rod...