iPhone 6 and above Passively Amplified Dock and Stand

Last crawled date: 6 years, 1 month ago

I wanted to design a useable iPhone dock and stand that was more visually appealing and a little less utilitarian and literal in form that were widely available on 3d printing websites. This dock is designed to take an iPhone with its case on - the slot dimension is 10mm thick x 70mm wide, so if the dimensions of your phone in its case are smaller than this, it will fit. The dock takes a standard lightning cable to allow phone charging while on the stand. The cable should be fed through the access through the back and base to position correctly in the dock. The cable at the back should be pushed into the ridge to secure it. This dock allows access to the home button while docked.

This model requires about 10m of filament producing a printed weight of about 25 grams. Good Luck with printing!