spaner

...ng options 40 degrees or 50 degrees print with supports and brim i have made it to break before the antenna so print a few spares

...s for my flight controller usb port on the matek f405 with the matek vtxpdb hope this is a useful thing for some of you out there

... on onshape (free cad) get it its great. i have never used cad of any type before and have only had my printer for 3 days so far.

...iend he needed to mount it on his quad a lumenier qav-r the hole centres in the mount are at 30mm so should fit quiet a few quads

...urved surface using hot glue . the antenna cable passes through the centre of the mast. print in tpu with supports and 50% infill

...l t mount. battery tray petg 50% infill gps mount petg 50% infill antenna mount tpu 50% infill and supports use hot glue to mount

...esigned to fit beitian bn-220 gps module print in tpu i use 50% infill print stood on end with brim and supports for best results

...down through the centre of the mast print base down with supports i print with 50% infill but that will depend on the tpu you use

...pneumatic spaner grabcad pneumatic spaner

...spanner grabcad untextured spanner grey spaner make it your own and tools spanner use...