13 rest racer 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Pod racer Turbines for Legion by ISOpod
...if you are using these as scatter terrain. the rest may roll around a...
thingiverse
free
Shuriken 120 Micro FPV Quad by ESylin
...the top plate (abs, acetone welding works great), the rest is assembled with "fun loom" rubber bands and 3m...
thingiverse
free
TILT PRO Racer 3D printed parts by The_Tilt_Drone_Racer
...most parts (especially structural ones) and pla in the rest of course you can print in any material you...
thingiverse
free
Another Spool Holder by Chalado
...through until it touches the end stop ring. the rest of the shafts should stick out by 2 mm....
thingiverse
free
Big Whoop 170mm 4S polycarbonate by Microdure
...one of my latest ultimaker polycarbonate prototype. built with rest of material "drawer bottom" a 160mm quadcopter equipped with...
thingiverse
free
Turtle Shell Racer High Power Edition Repaired by red112
...35c and around ~2000 to 2500mah. for example)http://www.hobbyking.com/hobbyking/store/__10273__turnigy_2450mah_2s_30c_lipo_pack.html the rest of the supplies you can refer to the original...
thingiverse
free
TILT 3DP Racer parts - Rev.4 by The_Tilt_Drone_Racer
...most parts (especially structural ones) and pla in the rest of course you can print in any material you...
thingiverse
free
WildWilly Dolphin 1 Frame Lightweight Gopro Hero 8 3D Parts by enrico320i
...they slide in gently and hold it self. the rest of the frame has stock steel screws, screws in...
thingiverse
free
Spec-R FPV Racer by Cronos-FDM
...without spacers. make sure it is level. prepare the rest of the wiring loom then fit the battery deck...
thingiverse
free
Mini T-Copter (TriCopter) by dmyers7
...the tail out at 90% fill for strength. the rest of the parts have been printed at 40% for...
thingiverse
free
Ruixin Pro RX-008 Knife sharpener Upgrades by leadingedge
...possible to hook the horizontal sharpening rod into its rest position when the fine tuning adapter is screwed further...
thingiverse
free
plot thermometer / clock EXPO pen parts by truglodite
...may cause problems. i measured my rig and it rest at 7*. so i made another sweeper that sits...
thingiverse
free
RS-LM 2014 Audi R18 E-Tron Quattro “The Ali" by wildcardfox
...the 24 hours of lemans june 17-18 “i’ve done wrested with alligators, i’ve tussled with a whale. i done...