12 pliers lug 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Lug Cap (Volkswagen) - 17mm by miklon
...file. to remove, you may want to use tongue-and-groove pliers as they are tight upon first...
thingiverse
free
19 mm Lug nut Cap NSX part by Pi-design
...depending on your rim, you may need a needle-nose pliers in the car to remove them if you need...
thingiverse
free
VW Amarok Multi-attachment adapter for air vent phone holder by MalphasWats
...it went in snugly using a small pair of pliers to twist it. accordingly i reduced their size slightly...
thingiverse
free
Version 1 of Cap less Dashboard instrument bulb holder T10 by darthwomble1
...to need to get a pair of needle nosed pliers out for the contacts. if you buy a pack...
thingiverse
free
Raspberry Pi Zero Stem Case v2.1 by Scriptwerx
...sd card for a pair of tweezers or small pliers the usb port for power is intentionally enclosed...
thingiverse
free
Fixed Flying Tourbillon Model Mark 2
...housing. i then used a pair of needle nose pliers to grab between the center hole and in between...
thingiverse
free
Vertex K8400 Power Inlet by jimconner
...of a sharp knife and a pair of needle-nosed pliers all the parts should print cleanly without any supports....
thingiverse
free
Xiaomi MiJia m365 - Rear wing support by Rahl
...the workpiece into the holes of the lugs using pliers 9) mount the wing with the workpiece installed in...
thingiverse
free
Amazon Echo Flex Accessory Enclosure by jamie-jb
...then squeeze them flat with a pair of needle-nose pliers gently insert the dev board into the saddle, being...
thingiverse
free
M17 threaded adapter
... probably add a fitting for nato cans with 40mm threads, russian cans with 39.7mm threads, and possibly for a nato gas mask hose.
thingiverse
free
SKR 1.4 Ender 5 Plus Mount inkl step down DC DC mount option final v1, v1.1 and v2.1 by Denise_Wink
...section 0.5 mm cross section 4mm cable lugs crimping pliers soldering iron shrink tubing m3 screws m3 nuts patience;)...
thingiverse
free
E3D Titan Aqua Mount for i3 mk3 by ChrisVahi
...for changing a nozzle ( they say to use pliers to secure the block, i use a 5/8" or...