21 frequency resistor 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Uranium glass oscillator
...reasonably slow rotation (use 100k and 0.1uf to increase frequency. the transistors i used are: 2n2222 and the led's...
thingiverse
free
eBay EZM328 ESR meter case by threeaxis
...item i bought is: 2016 ezm328(gm328r)transistor tester/ esr / frequency meter / square wave genera a link is (which...
thingiverse
free
Sad Robot Radio
...arm has two buttons to increase or decrease the frequency and the left arm has two buttons to increase...
thingiverse
free
4" transmission line speaker box by Jaisl
...glass wool or similar to get the wave response frequency down to approx. 60hz-> depending on the filling. it...
thingiverse
free
Arduino Player Piano New Guts by KiwiGrinder
...it will fit in an arduino uno. both the frequency and duration fixed length arrays have been combined into...
thingiverse
free
3d printed vacuum tube transmitter by SA2CLC
...turns is critical. one loose turn gives very good frequency stability, but only about 500mw, 4 turns gives close...
thingiverse
free
Race timer case by BMLfpv
...to set up. one node can monitor one video frequency (in the 5.8 ghz range). the hardware currently supports...
thingiverse
free
Air Raid Siren by brainlessgeneration
...version with 6 and 10 sounds a little low frequency it would be possible to increase the speed of...
thingiverse
free
Delta 5 Race Timer Shield Case by techyg
...to set up. one node can monitor one video frequency (in the 5.8 ghz range). the hardware currently supports...
thingiverse
free
Optical Bedlevel sensor for K8200/3Drag by tanteju
...a 47k resistor. lower impedance gives much higher scan frequency but it makes it harder to adjust correctly. it...
thingiverse
free
Bluetooth Speaker and Powerbank by skazarian
...closest to rated spec. i also wanted a low frequency (fs) of as close to 100khz as possible, and...
thingiverse
free
Wired Virtual Wall Barrier for iRobot Roomba Automatic Cleaner by Renaissance3DStudio
...= high; int khz = 38; // 38khz carrier frequency for irobot uint16_t counter = 0; // watchdog interrupt...
thingiverse
free
RF Item Tracker by littleStrong
...multilayer coil calculator -- https://www.circuits.dk/calculator_multi_layer_aircore.htm • resistance-frequency-capacitance calculator -- https://www.pad2pad.com/calculators/resistance-frequencycapacitance/ components list • 5volt voltage regulator -- https://www.mouser.com/datasheet/2/389/cd00000444-1795274.pdf •...
thingiverse
free
FlashForge 2016 LCD/SDCard/Keypad Interface Board Redesign by dewhisna
...roughly six times out of every ten card insertions. i believe i can safely claim they have completely resolved my sdcard issues.
thingiverse
free
Commodore 64--2021 by kevinthefixer
...and it turns out it's very sensitive to radio frequency interference. that white cube power supply has adequate rating...
thingiverse
free
Master-pi v3.0 by donaldsimonet
...cable. hdmi signal (not for this resolution) are high frequency so you can not just buy hdmi plug and...
thingiverse
free
Homemade Panelolu 2 I2C 20x4 LCD with sound for less then 12 euro (incl. simple shematic + sound modefication) ! by ooxtcoo
...when on ui feedback. ie screen click // #define lcd_feedback_frequencyduration_ms 100 // the duration the buzzer plays the ui...
thingiverse
free
Anet A6 - Autolevel bed sensor Blue SN-04N by d3adlydozen
...to pid_max //#define slow_pwm_heaters // pwm with very low frequency (roughly 0.125hz=8s) and minimum state time of approximately 1s...
grabcad
free
Tuning fork clock
...aa battery and consumes very little power. fine fork frequency adjustment is by the two brass nuts on top...
grabcad
free
Integrated circuits LM 555
...an oscillator, the • adjustable duty cycle free running frequency and duty cycle are accurately • output can source...
3dwarehouse
free
souvenir radio.
...to pre-adjust with a screwdriver. present royko is the frequency of rotation of the handle of which kpc yellow...