10 clamp winch 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
RC Winch Mk2 by SILVERADORED
...installed. uses m3 screws for the motor clamp. motor clamp will only fit in one orientation, if it isn't...
thingiverse
free
Superwinch Electrical Mounting by macjville
...most other pipe frames. the winch-solenoid parts are for clampng a single bolt post to the frame. i used...
thingiverse
free
Motor Winch Pulley for Linear Slide (Actobotics Hub 0.770" Pattern)
...half of the pulley, so print two copies and clamp them to a hub. use washers to spread the...
thingiverse
free
Toys for boys- rope winch/drums for construction crane by stollew
...make load. you will need few rells with roll clamp to glue in appropriate place and direct ropes. attention...
thingiverse
free
Linear Slide for Robotics (FRC / FTC / VEX) by ayershirleyfirst
...pulley from rotating. washers should only be needed to clamp the cording. below is a link showing the operation...
thingiverse
free
Simple 5.8Ghz Antenna Tracker for ImmersionRC by boost_9jr
...plate standard (optional see note 5) 2 x cable clamp (optional) hardware 25 x m3 x 8mm socket cap...
renderosity
$12
Off-road for any vehicle
.../> led light bar<br /> roof rack<br /> rubber clamplt;br /> sand ladder<br /> shackle<br /> shovel<br /> snorkel...
thingiverse
free
Parts for 133% Ossum Jeep to fit RC 1/10 by edwardchew
...axles, you may request me to make a different clamp for the leaf spring. i don't have one. **screws...
3dwarehouse
free
DIY Elevator
...(9 meter) 5000 lb winch powered elevator with pipe clamp that activate when there is no tension on the...
3dwarehouse
free
Trusst CT-CS30
...down uncontrollably •m12 threaded top hole accepts trusst ctc-50 clamp to easily support lighting bars •35 mm top tube...