8 track rostock 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Extruder "Cap" to reduce filament buckling by jesse
...where filament can pop out if it gets off track ...
thingiverse
free
Idler pulley Rostock Max by greenlee
...max by greenlee thingiverse this will keep the belts trackng in the center of the towers. i printed the...
thingiverse
free
Rostock Prisma by JorgeRdgz
...the channel while the other keeps the top belt trackng just above and flush with the edges of the...
thingiverse
free
HE3d K200/K280 heated bed mounts by Curado
...6 m3x3mm rubber grommets for attaching to the aluminum track 12 m4x10 socket cap screws 12 m4 hammer nuts...
thingiverse
free
Gates Idler mounts for Rostock Max by tajd3
...right at the mouth of the inner and outer v-track which allowed the belt to rub on the ends...
thingiverse
free
Rostock Max Tower Braces by tajd3
...the largest hex wrench that would fit in the track to lift the t-slot nut into place for the...
thingiverse
free
Spring Bed Clip for Round Print Beds (Kossel, Rostock) by Transcendtient
...a hex head bolt (m3) is slid into the track of v-slot and tightened into place with a nut....
thingiverse
free
Filament Box Outlet by robertd33
...2 unchanged originals so it's a complete set without trackng it down. again... please read... this is for 2/3...